Set the power output of RF1 to the external
LNB.
Off, 13V, 18V, V-NIT, or
H-NIT.
V-NIT and H-NIT will use
vertical and horizontal
polarity until it is
automatically read from
the NIT.
Note: Power will not be
applied to the LNB when
set to Off.
For dual band applications, select whether to
transmit the 22 kHz tone Local Oscillator
control signal of RF1.
On, Off, or Auto.
Auto uses the crossover
frequency to determine if
the tone is transmitted.
IP Input
Select the input to be active.
Note: Setting a new input to be active will
deactivate the currently active input.
Select which tables are required for the service
list creation and signal acquisition.
Note: When editing the tuning, the device is in
a transient state while acquiring tuning
information and channel lists, and so on. The
receiver reverts to the previous set of tuning
settings/information and channels until these
changes are either saved or abandoned.
Basic - Requires NIT to be
present.
Auto - Uses all the service
list tables and it will
acquire if any service list
tables are present.
Custom - Uses the Custom
Tuning parameters,
specified by the user.
The default is Basic.
To Next Page
Loading...
Need help?
General
