74
Performing Switch Setup Configuration
Monitoring Switch Setup Configuration
Monitoring Switch Setup Configuration
Verifying the Switch Running Configuration
You can check the configuration settings that you entered or changes that you made by entering this privileged EXEC
command:
Switch# show running-config
Building configuration...
Current configuration: 1363 bytes
!
version 12.2
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname Switch A
!
enable secret 5 $1$ej9.$DMUvAUnZOAmvmgqBEzIxE0
!
.
<output truncated>
.
interface GigabitEthernet1/17
no switchport
ip address 172.20.137.50 255.255.255.0
!
interface GigabitEthernet1/18
mvr type source
<output truncated>
...!
interface VLAN1
ip address 172.20.137.50 255.255.255.0
no ip directed-broadcast
!
ip default-gateway 172.20.137.1 !
!
snmp-server community private RW
snmp-server community public RO
snmp-server community private@es0 RW
snmp-server community public@es0 RO
snmp-server chassis-id 0x12
!
end
To store the configuration or changes you have made to your startup configuration in flash memory, enter this privileged
EXEC command:
Switch# copy running-config startup-config
Destination filename [startup-config]?
Building configuration...
This command saves the configuration settings that you made. If you fail to do this, your configuration will be lost the
next time you reload the system. To display information stored in the NVRAM section of flash memory, use the show
startup-config or more startup-config privileged EXEC command.
For more information about alternative locations from which to copy the configuration file, see Working with the Cisco
IOS File System, Configuration Files, and Software Images, page 993
To Next Page
Loading...
