Cisco IE 4000 Software Configuration Guide

86
Configuring Cisco IOS Configuration Engine
Configuring Cisco IOS Agents
6. cns connect name [retries number]
[retry-interval seconds] [sleep seconds]
[timeout seconds]
Enters CNS connect configuration mode, specifies the name of
the CNS connect profile, and defines the profile parameters. The
switch uses the CNS connect profile to connect to
Configuration Engine.
 (Optional) retries number—Enters the number of connection
retries. The range is 1 to 30. The default is 3.
 (Optional) retry-interval seconds—Enters the interval
between successive connection attempts to the
Configuration Engine. The range is 1 to 40 seconds. The
default is 10 seconds.
 (Optional) sleep seconds—Enters the amount of time before
which the first connection attempt occurs. The range is 0 to
250 seconds. The default is 0.
 (Optional) timeout seconds—Enters the amount of time after
which the connection attempts end. The range is 10 to 2000
seconds. The default is 120.
7. discover {controller controller-type | dlci
[subinterface subinterface-number] |
interface [interface-type] | line line-type}
Specifies the interface parameters in the CNS connect profile.
 controller controller-type—Enters the controller type.
 dlci—Enters the active data-link connection identifiers
(DLCIs).
(Optional) subinterface subinterface-number—Specifies the
point-to-point subinterface number that is used to search
for active DLCIs.

interface [interface-type]—Enters the type of interface.
 line line-type—Enters the line type.
8. template name [ ... name] Specifies the list of CNS connect templates in the CNS connect
profile to be applied to the switch configuration. You can specify
more than one template.
9. Repeat Steps 7 to 8 to specify more interface parameters and
CNS connect templates in the CNS connect profile.
10. exit Returns to global configuration mode.
11. hostname name Enters the hostname for the switch.
12. ip route network-number (Optional) Establishes a static route to Configuration Engine
whose IP address is network-number.
Command Purpose

Cisco IE 4000 Specifications

General

Product Type	Switch
Form Factor	DIN Rail Mountable
MAC Address Table Size	8000
Jumbo Frame Support	9216 bytes
Operating Temperature	-40°C to 70°C
Mean Time Between Failures (MTBF)	Over 500, 000 hours
Memory	256 MB DRAM
Mounting	DIN Rail, Wall
Certifications	EN 50121-4
Ports	8 x 10/100Base-TX Ethernet Ports