954
Configuring IPv6 Unicast Routing
Configuration Example
IPv6 is enabled, link-local address is FE80::20B:46FF:FE2F:D940
Global unicast address(es):
3FFE:C000:0:1:20B:46FF:FE2F:D940, subnet is 3FFE:C000:0:1::/64 [EUI]
Joined group address(es):
FF02::1
FF02::2
FF02::1:FF2F:D940
MTU is 1500 bytes
ICMP error messages limited to one every 100 milliseconds
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 200 seconds
ND router advertisements live for 1800 seconds
<output truncated>
This is an example of the output from the show ipv6 cef privileged EXEC command:
Switch# show ipv6 cef
::/0
nexthop 3FFE:C000:0:7::777 Vlan7
3FFE:C000:0:1::/64
attached to Vlan1
3FFE:C000:0:1:20B:46FF:FE2F:D940/128
receive
3FFE:C000:0:7::/64
attached to Vlan7
3FFE:C000:0:7::777/128
attached to Vlan7
3FFE:C000:0:7:20B:46FF:FE2F:D97F/128
receive
3FFE:C000:111:1::/64
attached to GigabitEthernet0/11
3FFE:C000:111:1:20B:46FF:FE2F:D945/128
receive
3FFE:C000:168:1::/64
attached to GigabitEthernet0/43
3FFE:C000:168:1:20B:46FF:FE2F:D94B/128
receive
3FFE:C000:16A:1::/64
attached to Loopback10
3FFE:C000:16A:1:20B:46FF:FE2F:D900/128
receive
<output truncated>
This is an example of the output from the show ipv6 protocols privileged EXEC command:
Switch# show ipv6 protocols
IPv6 Routing Protocol is “connected”
IPv6 Routing Protocol is “static”
IPv6 Routing Protocol is “rip fer”
Interfaces:
Vlan6
GigabitEthernet0/4
GigabitEthernet0/11
GigabitEthernet0/12
Redistribution:
None
This is an example of the output from the show ipv6 rip privileged EXEC command:
Switch# show ipv6 rip
To Next Page
Loading...
Need help?
General
