EasyManuals Logo

Cisco IE 4000 Software Configuration Guide

Cisco IE 4000
1066 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #959 background imageLoading...
Page #959 background image
955
Configuring IPv6 Unicast Routing
Configuration Example
RIP process "fer", port 521, multicast-group FF02::9, pid 190
Administrative distance is 120. Maximum paths is 16
Updates every 30 seconds, expire after 180
Holddown lasts 0 seconds, garbage collect after 120
Split horizon is on; poison reverse is off
Default routes are not generated
Periodic updates 9040, trigger updates 60
Interfaces:
Vlan6
GigabitEthernet0/4
GigabitEthernet0/11
GigabitEthernet0/12
Redistribution:
None
This is an example of the output from the show ipv6 neighbor privileged EXEC command:
Switch# show ipv6 neighbors
IPv6 Address Age Link-layer Addr State Interface
3FFE:C000:0:7::777 - 0007.0007.0007 REACH Vl7
3FFE:C101:113:1::33 - 0000.0000.0033 REACH Gi0/13
This is an example of the output from the show ipv6 static privileged EXEC command:
Switch# show ipv6 static
IPv6 Static routes
Code: * - installed in RIB
* ::/0 via nexthop 3FFE:C000:0:7::777, distance 1
This is an example of the output from the show ipv6 route privileged EXEC command:
Switch# show ipv6 route
IPv6 Routing Table - 21 entries
Codes: C - Connected, L - Local, S - Static, R - RIP, B - BGP
U - Per-user Static route
I1 - ISIS L1, I2 - ISIS L2, IA - ISIS interarea, IS - ISIS summary
O - OSPF intra, OI - OSPF inter, OE1 - OSPF ext 1, OE2 - OSPF ext 2
ON1 - OSPF NSSA ext 1, ON2 - OSPF NSSA ext 2
S ::/0 [1/0]
via 3FFE:C000:0:7::777
C 3FFE:C000:0:1::/64 [0/0]
via ::, Vlan1
L 3FFE:C000:0:1:20B:46FF:FE2F:D940/128 [0/0]
via ::, Vlan1
C 3FFE:C000:0:7::/64 [0/0]
via ::, Vlan7
L 3FFE:C000:0:7:20B:46FF:FE2F:D97F/128 [0/0]
via ::, Vlan7
C 3FFE:C000:111:1::/64 [0/0]
via ::, GigabitEthernet0/11
L 3FFE:C000:111:1:20B:46FF:FE2F:D945/128 [0/0]
C 3FFE:C000:168:1::/64 [0/0]
via ::, GigabitEthernet0/4
L 3FFE:C000:168:1:20B:46FF:FE2F:D94B/128 [0/0]
via ::, GigabitEthernet0/4
C 3FFE:C000:16A:1::/64 [0/0]
via ::, Loopback10
L 3FFE:C000:16A:1:20B:46FF:FE2F:D900/128 [0/0]
via ::, Loopback10
<output truncated>
This is an example of the output from the show ipv6 traffic privileged EXEC command.

Table of Contents

Other manuals for Cisco IE 4000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE 4000 and is the answer not in the manual?

Cisco IE 4000 Specifications

General IconGeneral
Product TypeSwitch
Form FactorDIN Rail Mountable
MAC Address Table Size8000
Jumbo Frame Support9216 bytes
Operating Temperature-40°C to 70°C
Mean Time Between Failures (MTBF)Over 500, 000 hours
Memory256 MB DRAM
MountingDIN Rail, Wall
CertificationsEN 50121-4
Ports8 x 10/100Base-TX Ethernet Ports

Related product manuals