DescriptionError/Warning MessageError/Warning
ID
A circuit cannot occupy different STS
regions on different spans. You may
add a different span or delete the
specified circuit.
You cannot add this span. It would cause the following
circuit(s) to occupy different {0} regions on different
spans: {1}
Either select a different span or delete the above
circuit(s).
EID-2127
An internal error occurred while trying
to remove a span from a BLSR.
This alarm occurs in the network-level
BLSR creation dialog box.
The state is invalid.EID-2128
Refer to the error message text.You cannot use same slot for east and west protect
ports.
EID-2129
Enter a ring ID value between 0 and
9999.
The ring ID value, {0}, is not valid. Please enter a valid
number between 0 and 9999.
EID-2130
You must select another reversion
type.
The reversion cannot be set to INCONSISTENT.EID-2131
Input/Output error. Unable to store
overhead circuit preferences.
The overhead circuit preferences could not be stored:
{0}
EID-2135
There was an error while merging the
circuits.
An error occurred during the circuit merge. {0}EID-2137
Refer to the error message text.Not all destinations could be deleted. Please try again.EID-2138
There was an error in updating the
circuit destinations.
An error occurred while updating the destinations.EID-2139
Select the version of online help, and
proceed.
No online help version was selected. The online help
book cannot be deleted.
EID-2143
You cannot delete the specified online
help.
An error occurred while deleting the online help
book(s). {0}
EID-2144
Refer to error message.No nodes appear to have a Cisco IOS card.EID-2145
You cannot logout of an account other
than your own.
This is a security violation. You may only logout of
your own account.
EID-2146
You cannot change an account other
than your own.
This is a security violation. You may only change your
own account.
EID-2147
You cannot delete the account you are
currently logged in.
This is a security violation. You cannot delete the
account under which you are currently logged in.
EID-2148
Refer to the error message text.There is no exportable content in this view.WID-2149
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
490
Error Messages
Error Messages Reference
To Next Page
Loading...
