Cisco SPA942 - Cisco - IP Phone User Manual

Configuring Security, Quality, and Network Features
Setting Optional Network Parameters
130 Cisco SPA and Wireless IP Phone Administration Guide
6
STEP 5 Click Submit All Changes.
DNS Server Order Specifies the method for selecting the DNS server. The
options are Manual, Manual/DHCP, and DHCP/Manual.
DNS Query Mode Do parallel or sequential DNS Query. With parallel DNS
query mode, the phone sends the same request to all
the DNS servers at the same time when doing a DNS
lookup, the first incoming reply is accepted by the
phone.
Defaults to parallel.
Not available on WIP310.
Syslog Server Specify the syslog server name and port. This feature
specifies the server for logging system information and
critical events. If both Debug Server and Syslog Server
are specified, Syslog messages are also logged to the
Debug Server.
Debug Server The debug server name and port. This feature
specifies the server for logging debug information. The
level of detailed output depends on the debug level
parameter setting.
Debug Level The debug level from 0-3. The higher the level, the
more debug information is generated. Zero (0) means
no debug information is generated. To log SIP
messages, you must set the Debug Level to at least 2.
Defaults to 0.
NTP Enable Enables Network Time Protocol (NTP).
Applies to the SPA525G only.
Primary NTP Server IP address or name of primary NTP server. The phones
use these servers to synchronize its time. Defaults to
blank.
Secondary NTP Server IP address or name of secondary NTP server. The
phones use these servers to synchronize its time.
Defaults to blank.
Parameter Description

Cisco SPA942 - Cisco - IP Phone Specifications

General

Brand	Cisco
Model	SPA942 - Cisco - IP Phone
Category	IP Phone
Language	English