Provisioning Basics
Upgrading, Resyncing, and Rebooting Phones
Cisco SPA and Wireless IP Phone Administration Guide 141
7
4-
Resyncing a Phone
You can resync an IP phone to a specific remote profile. The configuration of the
phone you resync will match the configuration of the remote phone. The phone
can be configured to resync its internal configuration state to a remote profile
periodically and on power up.
Use the following syntax to resync a phone’s profile to a profile on a TFTP, HTTP, or
HTTPS server:
http://phone-ip-addr/admin/resync?protocol://server-
name[:port]/profile-pathname
Log_Upgrade_Requ
est_Msg
Syslog message issued at the start of a firmware upgrade
attempt.
The default is
$PN $MAC -- Requesting upgrade $SCHEME://$SERVIP:$PORT$PATH
Log_Upgrade_Succ
ess_Msg
Syslog message issued after a firmware upgrade attempt
completes successfully.
The default is
$PN $MAC -- Successful upgrade $SCHEME://$SERVIP:$PORT$PATH
-- $ERR
Log_Upgrade_Failur
e_Msg
Syslog message issued after a failed firmware upgrade
attempt.
The default is
$PN $MAC -- Upgrade failed: $ERR.
License Keys This field is empty.
NOTE: The phone resyncs only when it is idle.
Parameter Description
To Next Page
Loading...
