Customizing Cisco SPA and Wireless IP Phones
Configuring Linksys Key System Parameters
56 Cisco SPA and Wireless IP Phone Administration Guide
4
Configuring Linksys Key System Parameters
To configure the phone as part of a Linksys Key System (for use with the
SPA9000):
STEP 1 Log in to the web administration interface.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the SIP tab.
STEP 4 Configure the following fields:
• Linksys Key System—Enables or disables the Linksys Key System for use
with the LVS SPA9000. Defaults to yes. See the
Cisco SPA9000 System
Administration Guide
for more details.
• Multicast Address—Used by the SPA9000 to communicate with Cisco IP
phones. Defaults to 224.168.168.168:6061.
• Force LAN Codec—Used with the SPA9000. Choices are none, G.711u, or
G.711a. Defaults to none.
STEP 5 Click Submit All Changes.
Enabling Call Features
This section describes how to enable and disable call features on the phone.
Enabling Anonymous Call and Caller ID Blocking
STEP 1 Log in to the web administration interface.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the Phone tab.
To Next Page
Loading...
