Cisco SPA942 - Cisco - IP Phone

SPA and Wireless IP Phone Field Reference
Provisioning Tab
Cisco SPA and Wireless IP Phone Administration Guide 216
B
Linksys Key System Parameters
Provisioning Tab
For information about the Provisioning page, see the Cisco SPA Provisioning
Guide
.
Regional Tab
This section describes the fields for the following headings on the Regional tab:
• Call Progress Tones, page 217
• Distinctive Ring Patterns, page 219
• Control Timer Values (sec), page 220
• Vertical Service Activation Codes, page 221
• Vertical Service Activation Codes, page 221
• Outbound Call Codec Selection Codes, page 227
• Time (SPA525G Only), page 230
Parameter Description
Linksys Key System Enable or disable the Linksys Key System on the IP
phone.
Defaults to yes.
Multicast Address The multicast address is used by the SPA9000 to
communicate with the SPA IP phones.
Defaults to 224.168.168.168:6061.
Force LAN Codec The choices are: none, G.711u, or G.711a. Defaults to
none.