Configuring the SPA932 Attendant Console
Setting Up the SPA932 Attendant Console
178 Cisco SPA and Wireless IP Phone Administration Guide
9
In the following example, extension 3500 is used to add Subscribecontext to
point to the context. This is entered in the file sip.conf:
[3500]
type=friend
secret=3500
callerid="spa3500"<3500>
nat=no
context=home
mailbox=3500
Subscribecontext=home
...
...
Configuring the SPA932
Complete the configuration required for the extensions on your IP PBX and obtain
the following information:
• SPA9000 IP address or other hostname
• Phone extension numbers
To configure the SPA932:
NOTE Steps 1 through 4 are only required when the
Server Type
field is set to SPA9000.
These steps are not required for other server types such as BroadSoft and
Asterisk.
STEP 1 Connect to the web UI for the phone to which the SPA932 is connected.
STEP 2 Click Admin/Advanced on the web UI page.
STEP 3 Click the SIP tab.
STEP 4 Select yes from the
CTI Enable
drop-down list.
STEP 5 Click the SPA932 or Attendant Console tab. (If you do not see the SPA932 or
Attendant Console tab, check your firmware version, and upgrade as necessary.)
STEP 6 Select yes from the
Unit 1 Enable
drop-down list. If you have installed two SPA932
units, also select yes from the
Unit 2 Enable
drop-down list.
To Next Page
Loading...
