SPA and Wireless IP Phone Field Reference
System Tab
Cisco SPA and Wireless IP Phone Administration Guide 200
B
Primary DNS DNS server used by SPA9000 in addition to DHCP
supplied DNS servers if DHCP is enabled; when DHCP
is disabled, this is the primary DNS server.
Defaults to 0.0.0.0.
Secondary DNS DNS server used by SPA9000 in addition to DHCP
supplied DNS servers if DHCP is enabled; when DHCP
is disabled, this is the secondary DNS server.
Defaults to 0.0.0.0.
DNS Server Order Specifies the method for selecting the DNS server. The
options are Manual, Manual/DHCP, and DHCP/Manual.
DNS Query Mode Do parallel or sequential DNS Query. With parallel DNS
query mode, the SPA9000 sends the same request to
all the DNS servers at the same time when doing a
DNS lookup, the first incoming reply is accepted by the
SPA9000.
Defaults to parallel.
Syslog Server Specify the syslog server name and port. This feature
specifies the server for logging IP phone system
information and critical events. If both Debug Server
and Syslog Server are specified, Syslog messages are
also logged to the Debug Server.
Debug Server The debug server name and port. This feature
specifies the server for logging IP phone debug
information. The level of detailed output depends on
the debug level parameter setting.
Debug Level The debug level from 0-3. The higher the level, the
more debug information is generated. Zero (0) means
no debug information is generated. To log SIP
messages, you must set the Debug Level to at least 2.
Defaults to 0.
Primary NTP Server IP address or name of primary NTP server.
Secondary NTP Server IP address or name of secondary NTP server.
Parameter Description
To Next Page
Loading...
Need help?
General
