Cisco SPA942 - Cisco - IP Phone User Manual

SPA and Wireless IP Phone Field Reference
Regional Tab
Cisco SPA and Wireless IP Phone Administration Guide 225
B
Referral Services Codes These codes tell the SPA9000 what to do when the
user places the current call on hold and is listening to
the second dial tone.
One or more *code can be configured into this
parameter, such as *98, or *97|*98|*123, etc. Max total
length is 79 chars. This parameter applies when the
user places the current call on hold (by Hook Flash) and
is listening to second dial tone. Each *code (and the
following valid target number according to current dial
plan) entered on the second dial-tone triggers the
SPA9000 to perform a blind transfer to a target number
that is prepended by the service *code.
For example, after the user dials *98, the SPA9000
plays a special dial tone called the Prompt Tone while
waiting for the user the enter a target number (which is
checked according to dial plan as in normal dialing).
When a complete number is entered, the SPA9000
sends a blind REFER to the holding party with the
Refer-To target equals to *98<target_number>. This
feature allows the SPA9000 to hand off a call to an
application server to perform further processing, such
as call park.
The *codes should not conflict with any of the other
vertical service codes internally processed by the
SPA9000. You can empty the corresponding *code
that you do not want to SPA9000 to process.
Parameter Description

Cisco SPA942 - Cisco - IP Phone Specifications

General

Brand	Cisco
Model	SPA942 - Cisco - IP Phone
Category	IP Phone
Language	English