Cisco SPA942 - Cisco - IP Phone User Manual

SPA and Wireless IP Phone Field Reference
Regional Tab
Cisco SPA and Wireless IP Phone Administration Guide 233
B
The <weekday> value equals any value in the range 1-
7 (Monday-Sunday). It can also equal 0. If the
<weekday> value is 0, this means that the date to start
or end daylight saving is exactly the date given. In that
case, the <day> value must not be negative. If the
<weekday> value is not 0 and the <day> value is
positive, then daylight saving starts or ends on the
<weekday> value on or after the date given. If the
<weekday> value is not 0 and the <day> value is
negative, then daylight saving starts or ends on the
<weekday> value on or before the date given.
The abbreviation HH stands for hours (0-23).
The abbreviation mm stands for minutes (0-59).
The abbreviation ss stands for seconds (0-59).
The default Daylight Saving Time Rule is start=4/1/
7;end=10/-1/7;save=1.
NOTE Found in the Time section for the SPA525G.
Daylight Savings Time Enable Select yes to enable Daylight Saving Time.
NOTE Found in the Time section for the SPA525G.
DTMF Playback Level Local DTMF playback level in dBm, up to one decimal
place.
Defaults to -16.
DTMF Playback Length Local DTMF playback duration in milliseconds.
Defaults to .1.
Inband DTMF Boost Controls the amount of amplification applied DTMF
signals.
Choices are OdB, 3dB, 6dB, 9dB, 12dB, 15dB, or 18dB.
Defaults to 12dB.
Parameter Description

Cisco SPA942 - Cisco - IP Phone Specifications

General

Brand	Cisco
Model	SPA942 - Cisco - IP Phone
Category	IP Phone
Language	English