106 Gateway and Gateway 4 Manual v1.2
© Tieline Research Pty. Ltd. 2021
6. The status indicator is orange when Fuse-IP is enabled but no tunnel is created. It turns green
when a tunnel is active.
Fuse-IP Enabled & no tunnel created
Fuse-IP enabled & tunnel created
7. Double-check all settings on both the server and client codecs if the message Started, dialing
server... persists after turning Fuse-IP On.
Important Notes:
· Data is sent by the codec over the newly created 'tunnel' as soon as Fuse-IP is enabled,
even if a connection has not been configured and dialed. Depending on the number of
interfaces being used, the codecs may transmit and receive up to 24MB of data per hour
at each end of the link.
· The codec remembers the Fuse-IP enabled/disabled state on power up.
· For additional stability it is recommended that a fixed jitter buffer is configured when
streaming using Fuse-IP. The actual jitter buffer depth should account for the difference in
delay between the interfaces and the maximum jitter experienced. To determine the jitter
To Next Page
Loading...
