119
© Tieline Research Pty. Ltd. 2021
Gateway and Gateway 4 Manual v1.2
23.10
Configure Dial and Answer Programs
Supports program connections using up to 4 channels of audio
Displays program types that support 4 channels in/out
Supports program connections using up to 16 channels of audio,
depending on codec configuration purchased (between 8 and 16
channels available for purchase)
The Gateway 8 displays program types that support 8 channels
in/out; the Gateway 16 displays program types that support 16
channels in/out.
The Program Manager panel incorporates a wizard to configure a new program and all audio
stream settings. Before you configure a new codec program consider if:
· You want your codec to be capable of dialing and answering, dialing only or answering only.
· A backup connection is required.
The following section contains instructions for:
1. Configuring Point-to-Point Programs: Dialing
2. Configuring a Failover Connection or Auto Reconnect
3. Configuring the Codec to Answer Connections
4. Configuring Output Source Failover options, e.g. File Playback on Silence Detection.
For more information about programs and audio streams within programs see the section titled IP
Streaming, Programs and TieLink. Note: The following instructions will display how to configure a
dial and answer program, with a backup connection and file playback. If the codec will either dial or
answer only, select the option and the wizard will automatically display relevant screens to allow
you to configure the codec correctly.
Creating Multistream Programs in the Gateway
When configuring multiple stream programs use the same process to configure each audio stream
in turn. Port numbers are automatically assigned and can be adjusted as required. The default
Tieline ports are outlined in Default Program Ports. A wide range of different program types are
available for different contribution and distribution streaming applications.
To Next Page
Loading...
