Codec Tieline Gateway

To Next Page

To Previous Page

221

Gateway and Gateway 4 Manual v1.2

23.36.1 Rule Examples

Load a New Matrix on a Remote Codec

Rules can be configured to load different custom matrices in a codec on demand. There is also a

solution to allow a studio codec to activate a remote codec matrix change:

1. On the studio codec, create a program and configure a new rule with Use a local input to

toggle a remote output and then configure a local input (e.g. Local Control Port Input 1)

to activate a remote output (e.g. Remote Output 2).

2. On the remote codec, configure a new rule with Use an input to load a custom mix and

for the Input select Remote Input and the same Remote Output number as configured

previously on the studio codec rule (e.g. number 2 in this example).

It may seem a bit counter-intuitive to select a Remote Input in the rule on the remote codec to

perform the matrix change, which is actually referring to the Remote Output at the studio codec,

but this is correct.

Codec Tieline Gateway - Page 221