276 Gateway and Gateway 4 Manual v1.2
© Tieline Research Pty. Ltd. 2021
Configure a Static IPv4 Address in Gateway and Gateway 4
Static IP addresses are fixed addresses which are recommended for studio installations. Using a
static IP address ensures remote codecs can connect reliably using the same IP address over time.
1. Press the SETTINGS button.
2. Select Transports and press the button.
3. Use the down navigation button to select LAN1, LAN2 or a VLAN interface.
4. Select Configuration and then Usage and then the appropriate control and/or streaming
mode for the connection. Next, press the button.
5. Select IPv4 Mode and press the button.
6. Select Static and press the button.
7. Navigate to IPv4 Address and enter the IP address (using the keypad or onscreen
keyboard), then press the button (or select Enter using the onscreen keyboard).
8. Navigate to IPv4 Subnet and enter the Subnet Mask, then press the button.
9. Navigate to IPv4 Gateway and enter the Gateway details, then press the button.
10. Press the Return button, then select Save in the confirmation dialog and press the
button to confirm the new settings.
11. Check the Unit Details menu to ensure the new static IP address has been entered
correctly.
Configuring a Static Public or Private IP Address in Genie, Merlin and
Bridge-IT (v.2.x firmware) Codecs
1. Press the SETTINGS button.
2. Select Network and press the button.
3. Use the down navigation button to select LAN1, LAN2, Wi-Fi or a VLAN interface.
4. Select Config and then Usage and then the appropriate control and/or streaming mode for
the connection. Next, press the button.
5. Select IPv4 Mode and press the button.
6. Select Static and press the button.
7. Navigate to IPv4 Static and enter the IP address, then press the button.
8. Navigate to IPv4 Subnet and enter the Subnet Mask, then press the button.
9. Navigate to IPv4 Gateway and enter the Gateway details, then press the button.
10. Use the up navigation button to scroll to the top of the menu and select Apply Setting,
then press the button to confirm the new settings.
11. Check the Unit Details menu to ensure the new static IP address has been entered
correctly.
Configuring a Static IP Address in Commander G3 and i-Mix G3 Codecs
To set up a static IP address in Commander G3 and i-Mix G3 codecs select Menu >
Configuration > Advanced > LAN settings > IP Setup > Setup > Static > IP Address >
[enter IP address] > press OK > Subnet Mask [enter Subnet Mask] > press OK > Gateway
[enter Gateway] > press OK > reboot the codec.
To Next Page
Loading...
