Need help?Do you have a question about the Cyan Z77 and is the answer not in the manual?
Provides Z22 shelf slot restrictions and line card placement guidelines for CEMi and service modules.
Provides Z33 slot restrictions and line card placement guidelines, including shelf manager requirements.
Provides Z77 slot restrictions and line card placement guidelines for various modules.
Describes Cyan Z-Series Lambda Add/Drop (LAD) modules for DWDM connectivity using thin film filter technology.
Describes DTM-8 and DTM-8G quad transponder modules for OTN optical channel encoding.
Describes the 2.5G-LME4 module, a 4-port muxponder with integrated OTN encoding for 10G wavelength transport.
Describes the PME-412, an Ethernet Layer 2 switch with integrated OTN functionality for transport.
Details Ethernet services, OAM, QoS, and synchronization features supported by the PME-412 module.
Describes the PME-216i, an advanced high-capacity Ethernet switch for MEF-compliant services.
Details Ethernet services, OAM, QoS, and synchronization features supported by PME-216i.
Describes the PSW-10G10, a 10-port 10 GbE switch module for Ethernet aggregation and transport.
Details Ethernet services and standards supported by the PSW-10G10 module.
Describes the TSW-10G10 module for Z77, providing grooming and aggregation of TESIs across 10G rings.
Describes the LAC-8 module, providing up to eight CWDM wavelengths for Z-Series transport platforms.
Describes the SFT-8, an 8-port SFP transponder supporting drop/insert/express traffic.
Describes the SFT-10G16, a high-density multi-rate transponder for CWDM and DWDM applications.
Describes the DTM-100G, a single-port 100 Gbps transponder module providing DWDM interfaces.
Describes the MSE-1482, an advanced SONET/SDH aggregation and transport module with integrated OTN.
Describes the FLX-216i, a multi-rate OTN muxponder for OTN switching and aggregation.
Describes WSS modules as ROADM for 40 ITU channels, supporting OOO switching and optical pass-through.
Describes the BOSS card for Z77 nodes, providing control, management, and timing interfaces.
Describes the BTM for Z77 shelves, providing physical termination for alarm and management interfaces.
Describes the XC-2800 switch fabric for Z77 shelves, providing unified packet and OTN switching.
Explains the redundancy and protection features of the XC-2800 fabric, including its 1:3 protected configuration.
Describes optical protection groups for DWDM/CWDM modules, providing reliable protection for failures.
Details equipment for optical protection groups, including the Transport Protection Module (TPM).
Provides rules and guidelines for planning and provisioning optical protection groups.
Describes the OPS, a low-loss switching technology for protection against fiber cuts and failures.
Explains the 1+1 protection mechanism of the OPS, including signal splitting and selection.
Lists typical 80 km DWDM XFP specifications with OTU2 Generic Forward Error Correction (GFEC) functionality.
Shows typical and maximum power consumption for the Z22 system components.
Shows typical and maximum power consumption for the Z33 system components.
Shows typical and maximum power consumption for the Z77 system components.
Provides guidance on sizing fuses according to NEC standards based on system current draw.
General| Brand | Cyan |
|---|---|
| Model | Z77 |
| Category | Network Hardware |
| Language | English |
To Next Page