EasyManua.ls Logo

Cyan Z77 - 2.5 G-LME4 Multiplex-Transponder Module

Default Icon
216 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cyan Z-Series Engineering and Planning Guide Release 5.0
Page 66 © 2013 Cyan, Inc.All Rights Reserved. 700-0023-05-00 Rev. 1
2.3 2.5G-LME4 Multiplex-Transponder Module
The Cyan Z-Series 2.5G-LME4 is a 4-port muxponder (multiplex-transponder) module with integrated
OTN encoding for efficient 10G wavelength transport in the Z-Series multi-layer transport platforms.
Each module accepts any combination of up to four 2.5G OC-48, STM-16, and/or OTU1 signals that are
encoded/translated into discrete ODU1s and then multiplexed into a high-capacity 10G OTU2 wavelength
for managed DWDM transport.
Figure 32: Z-Series 2.5G-LME4 Module
Note: An ODU1 Express cross-connect (OC-48/STM-16 express) between a pair of 2.5G-LME4
modules requires a Ring Closure Module (RCM) to be installed in the Z77 shelf or a Release 4.0 (or
higher) Z77 shelf equipped with the XC-2800 switch fabric. RCMs and the XC-2800 switch fabric are
not required for the Z22 or the Z33 shelf.
The Release 4.0 (or higher) XC-2800 switch fabric consists of four individual switch-fabric modules
installed in the Z77 horizontal EFM slots. For additional information on the XC-2800, see XC-2800
Switch Fabric starting on page 135.
For additional information on the RCMs, see Ring Closure Modules starting on page 135.
The graphic below shows the 2.5G-LME4 muxponder functional block diagram.
Up to 4 2.5G Client
Interfaces (SFPs)
Any Combination of:
Up to 4 OTU1
Up to 4 OC-48
Up to 4 STM-16
ODU2
Mux/Demux
OTU2 10G Trunk Interface
(DWDM XFPs)
1 OTU2
Figure 33: Z-Series 2.5G-LME4 Functional Block Diagram
Trunk Interface
The 2.5G-LME4 module utilizes a single XFP for its trunk interface. Optical performance is determined by
the DWDM multiplexing components and the XFP module in use.
Line format: OTU2
FEC: GFEC – G.975, 10.709 Gbps; UFEC – G.975.1 Appendix 7, 11.095 Gbps
Client Interfaces
The 2.5G-LME4 module utilizes four SFP modules for client interfaces.
Line formats: OTU-1, OC-48, STM-16
FEC (OTU-1): GFEC – 9.75, 2.68 Gbps
Jitter and wander: GR-253 compliant

Table of Contents

Related product manuals