Cyan Z-Series Engineering and Planning Guide Release 5.0
700-0023-05-00 Rev. 1 © 2013 Cyan, Inc. – All Rights Reserved. Page 191
Option 2 – Partial OSPF network:
• Configure the Planet Operate server with static routes to reach the Cyan nodes. In the example
configuration above, static routes in the Planet Operate server should be set up as follows:
10.1.2.0 / 255.255.255.0 / gw 10.2.1.1
10.1.3.0 / 255.255.255.0 / gw 10.2.1.1
10.1.4.0 / 255.255.255.0 / gw 10.2.1.1
– or –
0.0.0.0 / 0.0.0.0 / gw 10.2.1.1 (default route)
• Enable OSPF on the router on the LAN that it is sharing with the Cyan gateway node (LAN B in the
diagram above).
• Enable OSPF on both of the Cyan gateway nodes (10.1.1.2 and 10.1.1.3 in the diagram above).
To Next Page
Loading...