EasyManua.ls Logo

Cyan Z77 - Page 30

Default Icon
216 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Cyan Z-Series Engineering and Planning Guide Release 5.0
Page 30 © 2013 Cyan, Inc.All Rights Reserved. 700-0023-05-00 Rev. 1
Utilizing GbE and 10GbE switching and transport, the Z33 platform provides 2.5G CWDM transport, 10G
DWDM transport, OTN digital wrapper functionality, and multi-layer optimization and management.
The Z33, with a WSS-402 or WSS-404 module installed and paired with a passive AWG-40 optical patch
panel, provides a full ROADM with OOO switching and optical pass through. The WSS-402 provides 2
degrees and the WSS-404 provides 4 degrees of 40-wavelength cross-connect capacity in a single Z33 shelf.
Each WSS module provides optical add/drop multiplexing capability in the 1550nm band across
pre-defined ITU channel designations with 100 GHz spacing.
The shelf is optimized for edge and access node applications. The 5
RU chassis with six line card slots and
two common equipment modules can be equipped with any combination of Ethernet, CWDM, and DWDM
line cards to support a range of advanced services and applications. Further scalability is accomplished by
simply adding additional Z33 shelves or by redeploying interchangeable Z33 line cards into the
larger-capacity Z77 platform for increased aggregation and grooming.
The Z33 shelf provides the following key features:
Supports 1 to 40 lambda 10G waves in ITU grid 100 GHz DWDM channel spacing.
Supports CWDM (20nm spacing) capability with the addition of the LAC-8 module.
Supports addition of 2.5G waves using SFT-8 modules.
Supports 2-degree (East/West) configurations (WSS-402) or 4-degree (North/South/East/West)
configurations (WSS-404).
6 service slots, 2 Common Equipment Module (CEMi) slots (A and B).
All Z-Series modules are hot-swappable.
Over 100 Gbps per slot capacity.
Service cards are common with the Z-Series platform. The CEMi controller cards are specific to the
Z33 and Z22 chassis.
The card/slot restrictions are as follows:
Slots 1 and 2 must be the first slots that are occupied in the chassis.
Slots 1 and 2 must contain a line card with management processing capability. These line cards
include: 2.5G-LME4, PME-412, PME-216i, DTM-8, DTM-8G, DTM-100G, SFT-8, SFT-10G16,
MSE-1482, WSS-402, and WSS-404 but not any LAD or LAC-8 modules.
Chassis Capacity
Packet: Up to 240 Gbps of protected services
Optical:
4-degree, 40-channel ROADM
4, 8, or 40 channel, C-Band Terminal Mux
Tunable or Fixed wavelength transceiver options
Redundancy and Protection
Redundant fans
Redundant power connections
Equipment Protection: 1:1 for all common cards and service modules

Table of Contents

Related product manuals