Daedong DK4520 - Page 215

58
8
-
45
MAINTENANCE
WARNING
• If using a bulb other than the
specied one, the lamp can be
damaged and the tractor can
even catch re.
• Make sure to use bulbs with the
specied capacity.
CAUTION
• Make sure to use a KIOTI genuine
bulb. Using a non-recommended
bulb can cause a re.
• The headlamps can temporarily
be fogged due to rain or car
wash. This is because of the
temperature di󰀨erence between
the inside and outside of the
lamp, which is normal.
The halogen work lamps are designed
to enhance the visibility during work.
Do not touch the illuminating part of
the halogen bulb.
The bulb life can be shortened by
nger prints, dust and moisture, or
the bulb even can be broken. Clean it
with soft cloth.
Be careful of the following when re-
placing the halogen bulb :
• Replace the bulb after it is cooled
down.
• Do not touch the glass of the bulb.
• Handle the bulb with care and be
careful not to scratch or rub it.
• Do not let the bulb contact with liquid
when it is illuminated.
• Wear protective glasses when re-
placing the bulb.
WORK LAMP (CABIN)
(1) Connector
(2) LED Lamp Assembly
2
2
2
1
1
11
T23O702A
2. Disconnect the wire connector.
3. Undo the mounting nut to remove
the LED lamp assembly.
4. Install the new LED lamp assem-
bly and connect the connector.
OM_TD220(DK4220,4520,4720,5020,5320,5520,6020)-EN(USA)_08.indd 45OM_TD220(DK4220,4520,4720,5020,5320,5520,6020)-EN(USA)_08.indd 45 2023-09-22 오전 11:36:192023-09-22 오전 11:36:19