DAELIM DAYSTAR - Electrical System Checks; Fuse Replacement and Wiring

4-9
Fuel System
Jet
 Remove the main jet, needle jet holder, and
needle jet. Remove the slow jet, Remove the
pilot screw after recording the number of turns
until the pilot screw is tightened to clockwise
completely.
 Do not tighten up the Pilot screws by force.
It can cause the damaging of the seat part.
 Remove the throttle stop screws.
 Clean the jet with cleaning solvent.
 Inspect the pilot screws and jets and change the
wear and tear parts with new ones.
Installation
!
CAUTION
△
Main Jet
Main Jet
Main Jet
Main Jet
Main Jet
Main JetMain Jet
Main Jet
Main Jet
Main Jet
Main Jet
Main Jet
Main Jet
Needle Jet Holder
Needle Jet Holder
Needle Jet Holder
Needle Jet Holder
Needle Jet Holder
Needle Jet HolderNeedle Jet Holder
Needle Jet Holder
Needle Jet Holder
Needle Jet Holder
Needle Jet Holder
Needle Jet Holder
Needle Jet Holder
Slow Jet
Slow Jet
Slow Jet
Slow Jet
Slow Jet
Slow JetSlow Jet
Slow Jet
Slow Jet
Slow Jet
Slow Jet
Slow Jet
Slow Jet
Throttle Stop Screws
Throttle Stop Screws
Throttle Stop Screws
Throttle Stop Screws
Throttle Stop Screws
Throttle Stop ScrewsThrottle Stop Screws
Throttle Stop Screws
Throttle Stop Screws
Throttle Stop Screws
Throttle Stop Screws
Throttle Stop Screws
Throttle Stop Screws
Needle Jet
Needle Jet
Needle Jet
Needle Jet
Needle Jet
Needle JetNeedle Jet
Needle Jet
Needle Jet
Needle Jet
Needle Jet
Needle Jet
Needle Jet
Pilot Screws
Pilot Screws
Pilot Screws
Pilot Screws
Pilot Screws
Pilot ScrewsPilot Screws
Pilot Screws
Pilot Screws
Pilot Screws
Pilot Screws
Pilot Screws
Pilot Screws