5-2
Engine Removal / Installation
Service Information
General
● A floor jack or other adjustable support is required to support and maneuver the engine.
Be careful not to damage the frame, engine body, cables, wire system.
● The following parts or components can not be served with the engine installed in the frame.
● Cylinder head, valve(⇨ Chapter 8)
● Cylinder, piston(⇨ Chapter 9)
● Transmission, kick starter(⇨ Chapter 10)
● Crank shaft(Chapter 10)
Specification
● Engine oil capacity 1.2ℓ
Torque Values
● Engine hanger bolt(Front 1) 2.7kgf-m(27N.m)
(Front 1, Rear 2) 4.9kgf-m(49N.m)
● Gear change arm bolt 1.2kgf-m(12N.m)
● Drive sprocket bolt 1.2kgf-m(12N.m)
To Next Page
Loading...
