Configuring Devices 17
SIP server config Figure 5-7
If the VTO you are visiting works as SIP server
Select SIP Server Enable, and then click OK. The VTO reboots, and then the login
interface is displayed. After logging in, the Device Manager will display in the menu. You
need to add VTO and VTH then. See "5.1.1.5 Adding VTO" and "5.1.1.6 Adding VTH."
If third party server or other VTO work as SIP server, do not select the SIP Server Enable
check box, otherwise the connection will fail.
If other VTO works as SIP server
See Table 5-1 for the configuration, and then click OK. The VTO reboots, and then the
login interface is displayed.
Table 5-1 SIP server config (1)
The IP address of the VTO that works as SIP server.
The username and password of the SIP server.
If third party server works as SIP server
See Table 5-2 for the configuration, and then click OK. The VTO reboots, and then the
login interface is displayed.
Table 5-2 SIP server config (2)
The IP address of the server that works as SIP server.
To Next Page
Loading...
Need help?
General
