Daikin DCM601A52 - Page 288

User’s Manual EM11A015B
intelligent Touch Manager
287
Disconnection of communication with iTM
The iTM integrator accesses the iTM via a network. Therefore, communication with iTM may be
disconnected. Furthermore, communication may be disconnected due to power interruption in the
iTM unit, or initialization due to settings change.
If communication is disconnected when a screen of the accessed iTM is open on the iTM integrator,
the messages described in the following table are displayed.
Reason Timing Message
iTM restart causing settings change When iTM is shut down
<Controller name>
Communication disconnected.
Wait a moment to access
again.
iTM power interruption When iTM power goes down
Communication down due to network
causes
When communication goes down
Area deletion
When the “Yes” button is pressed on the
deletion conrmation dialog
<Controller name>
System settings changed.
Please access again.
Area member registration
When the “OK” button is pressed on the
Registration screen
Area attributes change
When the “OK” button is pressed on the
Area Attribute Setup screen
Area move
When the “OK” button is pressed on the
Area Move screen
Area CSV input
When the “Yes” button on the conrmation
dialog is pressed and saving is successful
Management point setup
When the “OK” button is pressed on the
Mgmt. Points Attributes Setup screen
iTM unit’s locale change
When the “OK” button is pressed on the
Locale screen
Centralized Monitoring Setup change
When the “OK” button is pressed on the
Centralized Monitoring Setup screen
Conrm Setup change
When the “OK” button is pressed on the
Conrm Setup screen
Changeover Option change When a Changeover Option is changed
Web user
Web Remote Management from the iTM integrator is permitted to managers only, and the
maximum number of managers you can register is 4.