12 • Quick Start Setup & Installation Xtium-CL MX4 User's Manual
Quick Start Setup & Installation
The following procedure outlines the basic steps required to install the Teledyne DALSA Xtium-CL
MX4. For complete installation details and information, see Installing Xtium-CL MX4.
Install the Xtium-CL MX4 in an available PCIe x4 (or x8) slot on the host computer.
If using PoCL, connect power to the board J7
connector.
Download and install the Sapera LT SDK software from the Teledyne DALSA website.
http://teledynedalsa.com/imaging/support/downloads/sdks/
Download and install the Xtium-CL MX4 device driver from the Teledyne DALSA website.
https://www.teledynedalsa.com/imaging/support/downloads/drivers/
To Next Page
Loading...