Xtium-CL MX4 User's Manual Quick Start Setup & Installation • 13
To complete the installation, update the Xtium-CL MX4 firmware when prompted; select
Automatic to update with the default configuration (Full Camera Link) or Manual to select
another option (2 Base Camera Link or 80-Bits Camera Link).
Reboot when all software and board drivers are installed.
Launch Sapera LT CamExpert
to verify the installation; the board should be present in
the list of available devices.
Connect camera(s) to the board Camera Link connectors. Ensure cameras are properly
powered.
If using PoCL, use CamExpert to enable the PoCL feature in the the Basic Timing
category.
To Next Page
Loading...