Danatronics ECHO Series - Using Non-Rechargeable AA Batteries

To Next Page

To Previous Page

ECHO Series Ultrasonic Thickness Gages

You may also use a computer instead of the wall charger to charge the gage, but this will

take significantly more time than using an AC outlet. If you decide to charge the gage

using this method, make sure the gage is powered off before you connect the USB to the

computer and to the gage itself.

When charging is complete, the F4 key will appear translucent in color. Power off the

gage, and unplug the charger from the USB connector on the top of the gage.

Using Non-rechargeable AA Batteries

A non-rechargeable alkaline AA pack is also available. This option requires a spare tray

and 3 AA batteries. Follow these steps to insert non-rechargeable batteries:

1. Un-screw the battery door.

2. Disconnect the Li-Ion battery connector.

3. Plug in the AA tray connector.

4. Replace the battery door and tighten screws.

Note: When using the 3 AA battery tray, batteries cannot be re-charged.