DDC Total-AceXtreme MIL-STD-1553 - Figure 23. Synchronous, Non-Multiplexed Address - 32-Bit Single-Word Memory Read Timing

HOST INTERFACE
Data Device Corporation DS-BU-67301B-G
www.ddc-web.com
1/14
63
Figure 23. Synchronous, Non-Multiplexed Address - 32-bit Single-Word Memory Read
Timing
Figure 23 Notes:
1. When nSELECT is asserted (low), the Total-AceXtreme® is selected for this
data transfer. nSELECT must be asserted through the full transfer cycle, and
de-asserted high at the end of the transfer.
2. The CPU_WORD_EN[1:0] inputs are used to specify which 16-bit data
memory words are valid for this transfer. If either or both these bits is ‘0’, then
the corresponding 16-bit word(s) will return a value of ‘0000’. These inputs
should be tied high if unused.
3. Unless the Total-AceXtreme command FIFO is full, CPU_nSTOP will not be
asserted for memory accesses, and will remain high.
nDATA_RDY
CPU_DATA
CPU_WORD_EN[1:0]
RD_nWR
MEM_nREG
CPU_ADDR
nDATA_STRB
nSELECT
HOST_CLK
CPU_nSTOP
tSH
tCLK
tRDD tRDD
tSS
tCS tCH
tOHZ
tOH
tDD
Address
Data
tAS
tAS
tAS
tAS
tAH
tAH
tAH
tAH
tWait
tSHC
CPU_nLAST