Dell 8 - Show Ip Route

Dell Converged Enhanced Ethernet Command Reference 93
53-1002115-01
show ip route
5
show ip route
Displays the current IP routing information.
Synopsis show ip route {| [ip-address [/mask] |longer-prefixes | static | connected | summary | all]
Operands ip-address/mask Mask for the route to be displayed. Valid values are integers between 0 and
32.
longer-prefixes Specifies that only routes matching the ip-address and mask pair should be
displayed.
static Display static routes only.
connected Display connected routes only.
summary Summary of all routes.
all Shows both inactive and active routes.
Description Use this command to display the current IP routing information.
Defaults There are no default configurations for this command.
Command
Modes
EXEC mode
User Guidelines There are no usage guidelines for this command.
Example Example output of this command:
switch>show ip route all
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
Gateway of last resort is 10.32.144.1 to network 0.0.0.0
10.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
S 10.0.0.0/8 [1/0] via 10.32.144.1
C 10.32.144.0/20 is directly connected, GigabitEthernet4/47
S* 0.0.0.0/0 [1/0] via 10.32.144.1
See Also show ip route summary