Dell 8 - Cee-Map

240 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
cee-map
16
cee-map
Enters the CEE map configuration mode.
Synopsis cee-map default
no cee-map
Operands default The CEE map name.
Defaults There is no default value for this command.
Command
Modes
Global configuration mode
Description Only a single CEE map is allowed, named “default”. It is created when system starts up. The initial
configuration of the default CEE map is:
Precedence 1
Priority Group Table
1: Weight 40, PFC Enabled, TrafficClass 3, BW% 40
2: Weight 60, PFC Disabled, TrafficClass 6, BW% 60
15.0: PFC Disabled
15.1: PFC Disabled
15.2: PFC Disabled
15.3: PFC Disabled
15.4: PFC Disabled
15.5: PFC Disabled
15.6: PFC Disabled
15.7: PFC Disabled
Priority Table
CoS: 0 1 2 3 4 5 6 7
---------------------------------------------
PGID: 2 2 2 1 2 2 2 2
FCoE CoS: None
Enabled on the following interfaces
Usage
Guidelines
Use no cee-map to revert to the default values for the map.
Examples none
See Also cee, priority-group-table, priority-table, fcoe-map