Dell 8 - Lldp Profile

Dell Converged Enhanced Ethernet Command Reference 109
53-1002115-01
lldp profile
6
lldp profile
Applies a Link Layer Discovery Protocol (LLDP) profile on an interface.
Synopsis lldp profile name
no lldp profile
Operands name Specifies the profile name.
Defaults If the parameters are not defined in the profile, the default values are used.
Command
Modes
Interface configuration mode
Description Use this command to apply a Link Layer Discovery Protocol (LLDP) profile on an interface. Use the
no lldp profile command to delete the profile from the interface.
Usage
Guidelines
You must use the profile command to create an LLDP profile before you can apply the profile to the
interface. Only one LLDP profile can exist at any time for a particular interface. When this command
is not present, the parameters defined in the global LLDP configuration are used.
Examples To apply an LLDP profile on an interface:
switch(conf-if-te-0/1)#lldp profile test
See Also protocol lldp