Dell 8 - Debug Lldp Packet

Dell Converged Enhanced Ethernet Command Reference 103
53-1002115-01
debug lldp packet
6
debug lldp packet
Enables debugging for Link Layer Discovery Protocol (LLDP).
Synopsis debug lldp packet {all | interface {in | ex}tengigabitethernet slot/port} [both | detail [both | rx | tx]
| rx | tx]
no debug lldp packet {all | interface {in | ex}tengigabitethernet slot/port}
Operands all Turns on LLDP packet debugging on all interfaces.
interface Use this keyword to specify any of the following interfaces:
extengigabitethernet
Specifies a valid external 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
intengigabitethernet
Specifies a valid internal 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
both Turns on debugging for both transmit and receive packets.
detail Turns on debugging with detailed information.
rx Turns on debugging for only received LLDP packets.
tx Turns on debugging for only transmitted LLDP packets.
Defaults By default, debugging is not turned on.
Command
Modes
Privileged EXEC mode
Description Use this command to enable debugging for Link Layer Discovery Protocol (LLDP). Use the no debug
lldp packet command to disable debugging.
Usage
Guidelines
To display debugging outputs on a particular cmsh session, use the terminal monitor command.
Examples To enable debugging of LLDP for both received and transmitted packets on 10 Gbps Ethernet
interface 0/1:
switch#debug lldp packet interface intengigabitethernet 0/1 both
switch#show debug lldp
LLDP debugging status:
Interface te0/1 : Transmit Receive
See Also show debug lldp