Dell 8 - Spanning-Tree Link-Type

190 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
spanning-tree link-type
11
spanning-tree link-type
Enables and disables the rapid transition for the Spanning Tree Protocol.
Synopsis spanning-tree link-type [point-to-point | shared]
no spanning-tree link-type
Operands point-to-point Enables rapid transition.
shared Disables rapid transition.
Defaults The default is point-to-point.
Command
Modes
Interface configuration mode
Description Use this command to specify a link type for the Spanning Tree Protocol.
Usage
Guidelines
This command overrides the default setting of the link type.
Examples To specify the link type as shared:
switch(conf-if-te-0/0)#spanning-tree link-type shared
See Also spanning-tree link-type shared, no spanning-tree link-type