Dell 8 - Terminal Length

Dell Converged Enhanced Ethernet Command Reference 43
53-1002115-01
terminal length
2
terminal length
Sets the number of lines to display on a screen.
Synopsis terminal length number
Operands number Specifies the number of lines to display on a screen. The range of valid values
is 0-512.
Defaults The default length is 24.
Command
Modes
Privileged EXEC mode
Description Use this command to set the number of lines to display on the screen.
Usage
Guidelines
If 0 (zero), the switch does not pause between screens of output.
Examples To set the number of lines to display on the screen to 30:
switch#terminal length 30
See Also none