Dell Converged Enhanced Ethernet Command Reference 163
53-1002115-01
error-disable-timeout interval
11
error-disable-timeout interval
Synopsis error-disable-timeout interval seconds
Operands seconds Specifies the range of time in seconds for the interface to time out. The range
of valid values is 10-1000000.
Defaults The default is 300 seconds. The timeout feature is disabled.
Command
Modes
Protocol Spanning Tree mode
Description Use this command to set the interface to time out when an error occurs.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To set the timeout value to 10 seconds:
switch(conf-rstp)#error-disable-timeout interval 10
See Also error-disable-timeout enable
To Next Page
Loading...
