Dell Converged Enhanced Ethernet Command Reference 169
53-1002115-01
port-channel path-cost
11
port-channel path-cost
Sets the path-cost behavior.
Synopsis port-channel path-cost [custom | standard]
Operands custom Specifies to use the custom behavior, which sets the path-cost changes
according to the port-channel’s bandwidth.
standard Specifies to use the standard behavior, which sets that the path-cost does not
change according to port-channel’s bandwidth.
Defaults The default path-cost is standard.
Command
Modes
Protocol Spanning Tree mode
Description Use this command to set the path-cost behavior for the port-channel.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To set the behavior for the path-cost to custom:
switch(conf-mstp)#port-channel path-cost custom
To set the behavior for the path-cost to standard:
switch(conf-mstp)#port-channel path-cost standard
See Also none
To Next Page
Loading...
