Dell 8 - Show Startup-Config

38 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
show startup-config
2
show startup-config
Displays the content of the startup configuration file.
Synopsis show startup-config
Operands none
Defaults There are no default configurations for this command.
Command
Modes
Privileged EXEC mode
Description Use this command to display the contents of the startup configuration file.
Usage
Guidelines
The following guidelines apply when using this command:
• An error displays if there are no entries in the startup configuration file, for example
switch#show startup-config
% No Startup-config
• Use the write memory command to add entries to the startup configuration file.
• Using the write erase command to delete entries from startup configuration file.
Examples To show the content of the startup configuration file:
switch#show startup-config
!
no protocol spanning-tree
!
interface Vlan 1
!
interface InTenGigabitEthernet 0/0
shutdown
!
interface InTenGigabitEthernet 0/1
shutdown
!
interface InTenGigabitEthernet 0/2
shutdown
!
interface InTenGigabitEthernet 0/3
shutdown
See Also write memory, write erase