Dell 8 - Qos Cos-Mutation

Dell Converged Enhanced Ethernet Command Reference 245
53-1002115-01
qos cos-mutation
16
qos cos-mutation
Applies a CoS-to-CoS (COS) mutation QoS map on an interface.
Synopsis qos cos-mutation name
no qos cos-mutation
Operands name Specifies the name of the CoS mutation map.
Defaults There is no explicit CoS-to-CoS mutation QoS map applied; by default the inbound CoS equals the
outbound CoS.
Command
Modes
Interface configuration mode
Description Use this command to apply a CoS-to-CoS mutation QoS map on an interface.
Usage
Guidelines
This command applies a CoS-to-CoS mutation map on an interface. The qos cos-mutation
command is not available if the interface is in CEE Provisioning mode. Use the no qos cos-mutation
command to remove the CoS-to-CoS mutation map.
Examples To activate the CoS-to-CoS mutation QoS map on the interface:
switch(conf-if-te-0/1)#qos cos-mutation test
To remove the CoS-to-CoS mutation QoS map on the interface:
switch(conf-if-te-0/1)#no qos cos-mutation
See Also qos map cos-mutation, show qos maps