Dell 8 - Sflow Commands; Sflow Collector

Dell Converged Enhanced Ethernet Command Reference 217
53-1002115-01
Chapter
13
sFlow Commands
sflow collector
Identifies the sFlow collectors to which sFlow datagrams are forwarded.
Synopsis sflow collector ip-address
no sflow collector
Operands ip-address Specifies the IP address in the dotted decimal format for the collector.
Defaults There are no defaults for this command.
Command
Modes
Interface Mode
Description Use this command to identify the sFlow collectors to which sFlow datagrams are forwarded.
Use the no sflow collector ip-address command to reset the specified collector address to a null
value.
Usage
Guidelines
You can only specify one sFlow collector.
Examples To identify the sFlow collectors for the IP address 192.10.138.176 to which sFlow datagrams are
forwarded:
switch(conf-if-te-0/1)#sFlow collector 192.10.138.176
See Also none