Dell 8 - Using the System Setup Program and UEFI Boot Manager; Choosing the System Boot Mode

Dell Converged Enhanced Ethernet Command Reference 111
53-1002115-01
multiplier
6
multiplier
Sets the number of consecutive misses of hello messages before LLDP declares the neighbor as
dead.
Synopsis multiplier value
no multiplier
Operands value Specifies a multiplier value to use. The range of valid values is 1-10.
Defaults The default multiplier value is 4.
Command
Modes
Protocol LLDP configuration mode
Description Use this command to set the number of consecutive misses of hello messages before LLDP
declares the neighbor as dead. Use the no multiplier command to return to the default setting.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To set the number of consecutive misses:
switch(conf-lldp)#multiplier 2
See Also hello