Dell 8 - Internet Group Management Protocol Commands; Clear Ip Igmp Group

Dell Converged Enhanced Ethernet Command Reference 199
53-1002115-01
Chapter
12
Internet Group Management Protocol Commands
clear ip igmp group
Clears information related to learned groups in the IGMP protocol module.
Synopsis clear ip igmp group [A.B.C.D [interface {in | ex}tengigabitethernet slot/port | interface port-channel
number | interface vlan vlan_id] | interface {in | ex}tengigabitethernet slot/port | interface
port-channel number | interface vlan vlan_id]
Operands A.B.C.D Specifies the group address, as a subnet number in dotted decimal format
(for example, 10.0.0.1), as the allowable range of addresses included in the
multicast group.
interface Use this keyword to specify any of the following interfaces:
intengigabitethernet
Specifies a valid external 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
extengigabitethernet
Specifies a valid internal 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
port-channel number
Specifies the interface is a port-channel. The range of valid values is 1-63.
interface Use this keyword to specify any of the following interfaces:
vlan vlan_id Specifies which VLAN interface to display the snooping configuration related
information. The range of valid values is 1-3583.
Defaults There are no defaults for this command.
Command
Modes
Privileged EXEC mode
Description Use this command to clear the group information in the IGMP database, including entries for either
a specific group on all interfaces or specific groups on specific interfaces.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To clear information for all groups in the IGMP protocol:
switch#clear ip igmp group