Dell 8 - Sflow Enable Interface

Dell Converged Enhanced Ethernet Command Reference 219
53-1002115-01
sflow enable interface
13
sflow enable interface
Enables sFlow on an interface.
Synopsis sflow enable interface
no sflow enable interface
Operands none
Defaults By default, sFlow is disabled on all interfaces.
Command
Modes
Interface Mode
Description Use this command to enable sFlow on an interface.
Use the no sflow enable interface command to disable sFlow on an interface.
Usage
Guidelines
This command is supported on physical ports and Link Aggregation Groups (LAG) ports. After a
physical port is a member of a LAG, it inherits the sFlow configuration from the LAG port.
Examples To enable sFlow on an interface:
switch(conf-if-te-0/1)#sflow enable interface
See Also sflow enable