Dell Converged Enhanced Ethernet Command Reference 279
53-1002115-01
dot1x timeout tx-period
17
dot1x timeout tx-period
Sets the number of seconds that the switch waits for a response to an Extensible Authentication
Protocol (EAP) request or identity frame from the client before retransmitting the request.
Synopsis dot1x timeout tx-period seconds
Operands seconds Specifies the time in seconds between successive request ID attempts. The
range of valid values is 1-65535.
Defaults The default timeout is 30 seconds.
Command
Modes
Interface configuration mode
Description Use this command to set the interval between successive attempts to request an ID (EAP ID Req).
Usage
Guidelines
There are no usage guidelines for this command.
Examples To set 34 as the number of seconds to wait for a response to an EAP-request or identity frame from
the client before retransmitting the request:
switch(config)#interface extengigabitethernet 0/16
switch(conf-if-te-0/16)#dot1x timeout tx-period 34
See Also none
To Next Page
Loading...
