Dell 8 - Show Interface

48 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
show interface
3
show interface
Displays the configuration and status of an interface.
Synopsis show interface [{in | ex}tengigabitethernet slot/port | port-channel number| switchport]
Operands tengigabitethernet
Specifies a valid 10 Gbps Ethernet interface.
slot Specifies a valid slot number.
port Specifies a valid port number.
port-channel number
Specifies the interface is a port-channel. The range of valid values is 1-63.
switchport Specifies the Layer 2 interface.
Defaults There are no default configurations for this command.
Command
Modes
EXEC mode
Description Use this command to show the running system status and configuration for a specified interface.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To display information for a 10 Gbps Ethernet interface:
switch#show interface intengigabitethernet 0/1
Interface name : InTenGigabitEthernet 0/7
Switchport mode : access
Ingress filter : enable
Acceptable frame types : all
Default Vlan : 1
Active Vlans : 1
Inactive Vlans : -
Interface name : InTenGigabitEthernet 0/1
Switchport mode : access
Ingress filter : enable
Acceptable frame types : all
Default Vlan : 5
Active Vlans : 5
Inactive Vlans : -
See Also show interface vlan