184 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
spanning-tree autoedge
11
spanning-tree autoedge
Enables automatic edge detection.
Synopsis spanning-tree autoedge
no spanning-tree autoedge
Operands none
Defaults Auto detection is not enabled.
Command
Modes
Interface configuration mode
Description Use this command to automatically identify the edge port.
Usage
Guidelines
The port can become an edge port if no Bridge Protocol Data Unit (BPDU) is received.
Examples To enable automatic edge detection:
switch(conf-if-te-0/1)#spanning-tree autoedge
See Also protocol spanning-tree
To Next Page
Loading...
