xiv Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
• Chapter 13, “sFlow Commands” describes the commands used to configure and maintain
sFlow.
• Chapter 14, “Port Mirroring Commands” describes the commands used to configure and
maintain port mirroring.
• Chapter 15, “RMON Commands” describes the Remote Network Monitoring (RMON)
commands used to monitor and collect long-term statistics.
• Chapter 16, “QoS Commands” describes the commands used to enable Quality of Service on
the device.
• Chapter 17, “Port Authentication Commands” describes the 802.1x port authentication
configuration commands.
Supported hardware and software
The following hardware platform is supported in this release:
• Dell M8428-k
Within this manual, any appearance of the term “Dell FCoE hardware” is referring to:
• Dell M8428-k
• Dell FCOE10-24 port blade
• Dell Converged 10GbE Switch Module for IBM BladeCenter
• Dell 2 port 10GbE Converged Network Adapter for IBM BladeCenter
Document conventions
This section describes text formatting conventions and important notice formats used in this
document.
Text formatting
The narrative-text formatting conventions that are used are as follows:
bold text Identifies command names
Identifies the names of user-manipulated GUI elements
Identifies keywords and operands
Identifies text to enter at the GUI or CLI
italic text Provides emphasis
Identifies variables
Identifies paths and Internet addresses
Identifies document titles
code text Identifies CLI output
Identifies command syntax examples
For readability, command names in the narrative portions of this guide are presented in mixed
lettercase: for example, switchShow. In actual examples, command lettercase is all lowercase.
To Next Page
Loading...
