246 Dell Converged Enhanced Ethernet Command Reference
53-1002115-01
qos cos-traffic-class
16
qos cos-traffic-class
Applies a CoS-to-Traffic Class QoS map on an interface.
Synopsis qos cos-traffic-class name
no qos cos-traffic-class
Operands name Specifies the name of a previously created CoS-to-Traffic Class QoS map. Only
one CoS-to-Traffic Class QoS map can exist at a time. An existing
CoS-to-Traffic Class QoS map must be removed before a new one can be
applied.
Defaults There is no explicit CoS-to-Traffic Class QoS map applied; the implicit behavior is to match the IEEE
802.1Q recommendations for systems supporting eight Traffic Classes.
Command
Modes
Interface configuration mode
Description Use this command to apply a CoS-to-Traffic Class QoS map to an interface. Use the no qos
cos-traffic-class command to remove the CoS-to-Traffic Class mapping.
Usage
Guidelines
This command is not available when the interface is in the CEE Provisioning mode.
Examples To apply a CoS-to-Traffic Class QoS map to an interface:
switch(conf-if-te-0/1)#qos cos-traffic-class test
See Also qos map cos-traffic-class, qos trust, qos cos-mutation, show qos maps
To Next Page
Loading...
